RFX

RFX Sport Plastic Throttle Sleeve (Black) 4 Stroke Kxf 04-22 /Rmz 04-22 /Yzf 97-22 Wrf 98-22

0 review Write a Review
SKU: FXTS 20300 00BK
UPC: FXTS 20300
Bike Brand: Kawasaki
Bike Brand: Suzuki
Bike Brand: Yamaha
Product Type: Throttle Tubes
Material: Plastic
Colour: Black
£4.99
Hurry up! Current stock:
  • fast-shipping-3.jpg

RFX Sport Plastic Throttle Sleeve (Black) 4 Stroke KXF 04-22 /RMZ 04-22 /YZF 97-22 WRF 98-22

RFX Sport Series Throttle Tubes are an exact replacement part at a fraction of the cost of genuine parts. They are made from a Teflon coated Nylon Fabric which provide you with a smooth action.

  • Replacement throttle tubes for all popular off road bikes.
  • Uses the same cam profile as the OEM part for proper throttle control.
  • Teflon coated Nylon Fabric provides smooth action.
  • Will not scar bars like aluminium tubes.
  • Open end design for use with aluminium hand guards if required. 

Fitting Instructions:

  • Slide the rubber boot down and disassemble the throttle housing, remove the old throttle tube taking care not to damage the throttle cables.
  • Carefully remove grip from the old throttle tube if required.
  • Inspect the cables and housing for excess damage or wear, clean and lube them or replace if required.
  • Clean the handlebar and inspect for damage where the old throttle tube has been spinning on the bar if a ridge is present replace the handlebars.
  • Slide the new throttle tube on the handlebar and lube using a penetrating lubricant preferably Maxima MPPL (do not use grease as this attracts dirt and makes the throttle stick after a short period of time).
  • Re-assemble the throttle cables and housing again using some penetrating lubricant.
  • Tighten the throttle housing in the correct position on the handlebars.
  • Adjust the cable to the required (free play amount) of your liking.
  • Rotate the handlebars to their maximum position to check proper operation of the throttle and correct cable routing, some re-adjustment of the cable may be required.
  • Slide the rubber boot back over the housing.
  • Cover the hole in the end of the grip with some electrical tape (To stop glue entering the throttle barrel) and apply a small amount of RFX grip glue to the outer end of the throttle tube on the outside diameter.
  • Apply a small amount of RFX grip glue to the inside of the new grip and slide onto the tube.
  • Twist the grip to the correct position and leave to dry.
  • Apply RFX safety grip wire if needed.
  • After the glue has dried again check proper operation of the throttle.   

Customers Also Viewed